Monthly Archives: February 2012

“Twinning” Furnaces

Posted on February 26, 2012 by yorkcentraltechtalk

There are some applications where a single furnace cannot deliver enough BTU’s or CFM to heat a space.  When these  applications arise, a simple solution may be to put in 2 furnaces and “twin” them together.  This allows both furnaces … Continue reading →

Posted in HVAC Tech Support | 22 Comments

X-13 MOTORS IN 3-PHASE UNITS

Posted on February 21, 2012 by yorkcentraltechtalk

 A lot of packaged roof top units are using Regal Beloit’s X-13 E.C.M. motor to raise the overall efficiency of the equipment and to improve the S.E.E.R. ratings on the units.  These are used primarily on small packaged units under … Continue reading →

Posted in HVAC Tech Support | Leave a comment

GREAT TRAINING OPPORTUNITY

Posted on February 14, 2012 by yorkcentraltechtalk

I just came back from a training session conducted by our Training Department in Norman, OK and I have to tell you all about it. JCI/York has put together a Training/Certification Program for Start-up and Commissioning of commercial equipment and … Continue reading →

Posted in Commentary | 2 Comments

FURNACE REPLACEMENT BOARDS FAULT CODE 9

Posted on February 1, 2012 by yorkcentraltechtalk

I am posting this again since there are probably a lot of Techs out there who are new to this site.  IF YOU ARE REPLACING ANY OF THE OLDER BOARDS IN A YORK FURNACE WITH THE NEW REPLACEMENT BOARDS:  S1-33102956000 … Continue reading →

Posted in HVAC Tech Support | 2 Comments